Showing 2 results for Sohrabi Bidar
A Zolfaghari, A Sohrabi Bidar, Mr Malekijavan, M Haftani,
Volume 8, Issue 2 (11-2014)
Abstract
Today the effects of grouting are usually confirmed by the results of permeability tests but this method is not enough to show the changes in mechanical properties of rock masses. Although many investigators use the in situ tests for evaluation of rock mass mechanical property improvement. But this tests are time consuming and expensive. Grouting reduces the permeability and improves the condition of joints and ultimately increases the rate of rock mass classification in rock engineering. So with measurement of rock mass quality index values (Q-value) in cores obtained from grouted boreholes, the efficiency and success in improving the mechanical properties of rock mass can be showed. This paper for first time introduces Q-logging as a simple method to assess the impact of grouting in improvement of the rock mass quality. Here in, the results of Q-Logging in trial injection panels in the Bakhtiary, Bazoft and Khersan II dams have been examined. The deformation modulus were calculated from the Q-Logging for before and after of grouting. Results show that there is a good agreement between calculated rock mass parameters based on the Q-Logging method and the measured from in-situ test in the studied site. This agreement confirms the efficiency and applicability of the Q- Logging method for assessment of grouting success as well as the estimation of the rock mass parameters in grouted areas. Also it has been shown that the deformation modulus in weak rock mass with low quality has been more improved than rock mass with beater quality.
Arash Shareghi, M Amelmelsak, A Sohrabi Bidar,
Volume 8, Issue 4 (3-2015)
Abstract
Evaluation of strong ground motion up beneath the construction is important in both geotechnical engineering (site effect) and earthquake engineering aspects (analysis of earth behavior). The common methods of microzonation in geotechnical engineering are based on one dimensional dynamic analysis, in which ground surface is assumed to be horizontal. However in many cases, because of variety of topography conditions, recorded responses are different on the top of hills and their corners. In this study, FLAC 2D software, as finite difference software, is used to analysis the trapezoidal hill with different shape ratios. These topography models are analyzed by far field earthquake records, and their dimensionless amplification ratios are compared with the obtained results of one dimensional analysis. Assessment of these two analyses methods in some points on the topography and around it, demonstrated considerable differences that show the necessity of two dimensional analysis in earthquake geotechnical engineering.
