, Ar Taleb Beydokhti, A Asiabanha,
Volume 6, Issue 1 (11-2012)
Abstract
Slake durability of rocks is an important engineering parameter for evaluating deterioration of rocks in chemical and physical agents that are related to mechanical properties of rock. The main purpose of this study is to assess the influence of the number of drying and wetting cycles under variable pH conditions and controls of mineralogical composition on durability. For this purpose, five different types of tuff were selected from different parts in north Qazvin city. The samples were subjected to multiple-cycle slake durability testing with different pH values solution. Also the slake durability tests in saturated condition on samples, petrographical analyses and basic physical - mechanical test were performed. In addition, to assess the influence of mineralogical composition on durability, the mineral contents of the original material and the material passing from the drum of the slake durability apparatus after fifteen cycles were also determined by XRD analyses. It was concluded that the slake durability of tuff is independent of the pH in acidic solution circumstances. Mineralogical composition, fabric and weathering rate are considered to have a greater influence on the slake durability of tuff. A strong relationship between the point load strength and the fifteenth-cycle slake durability index is found in the rock types studied.
Ali Akbar Moomeni, Ming Tao, Alireza Taleb Beydokhti,
Volume 14, Issue 4 (12-2020)
Abstract
Introduction
Shallow tunnels have a vital role in urban planning, railway and highway transportation lines. The presence of underground cavities can leads to stress concentration and consequently, instability of the spaces against static and especially dynamic loads. Therefore, the aim of this study was to evaluate the effect of elliptical cavity and its inclination on sandstone rock behavior under compressive static and tensile dynamic loads. In order to evaluate the effect of the cavity under static stress conditions, two groups of intact and hole-bearing sandstone cores with 0, 30, 60, and 90 degrees of hole inclination were prepared and tested under uniaxial compressive loading test. During the test, in addition to the stress recording, damage and deformability of the samples were recorded by using the strain gauge, acoustic emission sensor and camera. Split Hopkinson pressure bar (SHPB) test apparatus was used for doing dynamic loading test. Furthermore, the damage process was recorded using a high-speed camera with 10 micro-seconds interval of frame capability. The obtained results showed that presence of the cavity reduced the rock strength in maximum state (θ=0) up to 55% and in minimum state (θ=90) up to 77% of its initial uniaxial compressive strength. Dynamic tensile loading tests illustrate that the elliptical hole near the free end of sample (reflection boundary of compressive wave to tensile wave) is stable due to locating in superposition area, while the other cavity out of the area with each inclination was undergone to spalling failure. Assessment of failure surface using scanning electron microscope and thin section study indicates that the dominant fracture is grain-boundary type and iron oxide cement has a vital role in developing of this type of fracture.
